convergence problem

- December 1, 2020 at 3:01 pm
  
  Emperor
  Subscriber
  
  I am doing electromagnetic-structural coupling simulation. The electromagnetic part in Maxwell 3D is done without any problem. But for structural analysis in Ansys workbench getting convergence error. Can I have a suggestion to fix this error in Ansys 18.2?
  
  Please find the attached outfile of solution information.
  
  Thank you,
  
  Mosarraf
- December 1, 2020 at 4:00 pm
  
  Rob
  Forum Moderator
  
  Check the mesh, check the physics and check the initial conditions. Then try with a smaller time step.n