-
-
October 1, 2024 at 9:32 pm
Matteo.panep
Subscriberhello,I am simulating a car during the cornering phase.I am experiencing problems with the boundary conditions of the domain. I have set for the domain rotation the frame motion setting while for the inlet a velocity inlet condition with zero velocity and for the outlet a pressure outlet condition with zero pressure. However, it seems that with these conditions the flow does not rotate rigidly around the centre of curvature and I also have a reverse flow problem in the outlet. I am desperate, I am asking for help
Â
Â
-
October 2, 2024 at 1:36 pm
Rob
Forum ModeratorYou'll need to add flow from the inlet too. How did you model the straight line scenario?
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- How do I get my hands on Ansys Rocky DEM
- Non-Intersected faces found for matching interface periodic-walls
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Script Error
- Facing trouble regarding setting up boundary conditions for SOEC Modeling
- convergence issue for transonic flow
- Running ANSYS Fluent on a HPC Cluster
- Point exception in erosion calculation
- Errors with multi-connected bodies using AQWA
Top Contributors
-
1987
-
896
-
599
-
591
-
418
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.