Can you access damping by part in Workbench LS-Dyna?

- February 28, 2023 at 5:28 pm
  
  Ben_Ben
  Subscriber
  
  I would like to apply different dmping to different parts in my model. Can I do this in Workbench 2022 R2?
  
  This is what I would like to use, *DAMPING_PART_MASS:
  
  https://www.dynasupport.com/howtos/general/damping
- February 28, 2023 at 10:07 pm
  
  Andreas Koutras
  Ansys Employee
  
  Hello, it appears that the *DAMPING keywords are not supported by the WB LS-DYNA interface yet. However, they can be added via keyword snippets as shown below.
- March 2, 2023 at 10:32 am
  
  Ben_Ben
  Subscriber
  
  Hi Andreas,
  Thank you for your reply. Where can I find what each of the green coloured acronyms mean? and what numerical values to apply to them?
  
  Thanks,
  Ben