Learning Forum

[hzc16001]

Hello,

I am currently creating a model using symmetrical boundary conditions. The FE Model I am using is a quarter of the original model; with the planes of axis being the XY and ZY planes. I have applied the proper symmetrical boundary conditions to the edges along the XY and ZY planes, with the remaining 2 edges pin-supported. Regardless, I continue to receive an error stating " The solver engine was unable to converge on a solution for the nonlinear problem as constrained." Do you have any suggestions on how to resolve this?

Thank you

[peteroznewman]

This is a duplicate post to /forum/discussion/37486/ansys-symmetrical-boundary-conditions-error#latest
Please don't post duplicates.

[bhagwantP]

 

Hello hzc16001,

Please check multile posts already there in forum feed:

The solver engine was unable to converge on a solution for the nonlinear problem as constrained. (ansys.com)

How do I fix the error regarding the solver engine being unable to converge on a solution? (ansys.com)

The solver engine was unable to converge on a solution for the nonlinear problem as constrained. (ansys.com)

The solver engine was unable to converge on a solution for the nonlinear problem as constrained. (ansys.com)

The solver engine was unable to converge on a solution (ansys.com)

Non-linear structural: The solver engine was unable to converge (ansys.com)

Error about “unable to converge on a solution” (ansys.com)

The solver engine was unable to converge on a solution for the nonlinear problem as constrained. (ansys.com)

Thanks