airflow over tubes filled with PCM

- September 16, 2020 at 5:39 pm
  
  douniaextra1
  Subscriber
  
  Hello everyone,
  I facing a problem in Ansys Fluent.
  I'm simulating a 2D box that contains tubes filled with PCM.
- September 16, 2020 at 6:06 pm
  
  das.3
  Subscriber
  
  Did you create mesh interface?n
- September 17, 2020 at 10:07 am
  
  Rob
  Forum Moderator
  
  Use Share Topology in SpaceClaim or create a Multibody Part in DesignModeler, that avoids the need for interfaces. You will need to label the edges as walls though (Named Selections in Meshing). n