TAGGED: maxwell
-
-
May 29, 2024 at 2:39 pmPrateekee ChatterjeeSubscriber
I want to add a new material for a magnetostatic study. Three questions on that----
1) how do I add said new ferrite in the material list along with the extended Jiles artherton loss model parameters??
2) The material list does have the provision of adding loss model but I am not sure if that is anything standard- like what is 'Cm' , 'X', 'Y', 'Kdc', 'Equiv Out Depth'?
What model is this?
3) What is measured frequency at the top? What happens when I move to an eddy current study and do a frequency sweep? -
June 6, 2024 at 12:43 amHDLIAnsys Employee
Hello Prateekee,
   Please review Maxwell help manual to find definition of Cm, X, Y, Kdc, etc. You could use option of "Calculate properties for:" to get the coefficients based on the core loss data in materail properties dialog.Â
HDLI
Â
-
- The topic ‘Adding a Ferrite material in Ansys Material List’ is closed to new replies.
- HFSS Incident Plane Wave excitement mode
- Question for Maxwell
- Simulation of capacitor combining eddy currents with displacement currents
- How to calculate eddy and hysteresis losses of the core?
- How to calculate capacitance using Fields Calculator in HFSS?
- Ansys Maxwell 3D – eddy current
- How to determine initial position in motion setup
- Leakage inductance realization in transformer
- dq graph non-conformity
- How to customize pulse waveform and injection site in microstrip array
-
1131
-
468
-
466
-
225
-
201
© 2024 Copyright ANSYS, Inc. All rights reserved.