-
-
November 11, 2023 at 5:18 amMohammad QazaSubscriber
I have just started learning Ansys and I'm going through the basic example of 3D Magnetostatic Simulation of EMB Using Ansys Maxwell, model needed 20 minutes to solve eddy solver, with default meshing and solver setup exactly as in the course, am I missing some setting to speed up the solution?Â
Â
-
November 15, 2023 at 4:16 pmTimosAnsys Employee
Hello, if you are not simulating a frequency sweep, a possible reason of increased simulation time could be the number of passes until convergence. Please refer to:
Maxwell Help > Specifying Solution Settings and
Maxwell Help > Specifying Solution Settings > Setting Analysis Parameters for Non-Transient Solutions > Defining Settings on the Convergence Tab for Non-Transient Solutions
-
Viewing 1 reply thread
- The topic ‘3D Magnetostatic Simulation of EMB Using Ansys Maxwell’ is closed to new replies.
Ansys Innovation Space
Trending discussions
- Polarization and Angle of Incidence Scan with Floquet ports in ANSYS HFSS
- SLURM integration
- How to create Lumped RLC in HFSS to match Circuit? (Simulate load as Lumped RLC)
- CPW resonant frequency HFSS Simulation
- EMA3D Current Source Problem
- determining turn directions in cylindirical coil:clkwise-counterclkwise
- Zo when applying bulk conductivity to the silicon substrate of finite-ground CPW
- Simplorer link to Maxwell transient
- Help on calculating port impedance Zpv using Field calculator under HFSS please
- Question for Maxwell
Top Contributors
-
761
-
407
-
264
-
201
-
162
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.