We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum Forums Discuss Simulation Fluids Overlapping Reply To: Overlapping

guilherme.rodrigues
Subscriber

Yes, I followed the tutorials and uploaded a photo below of the wind tunnel example. I know that the laminar region will start at the entry of the heat sink and end at the exit of the heat sink. What I want to understand is why it's giving overlapping (contextualizing). I am performing two Boolean operations (Tool - heat sink / Target - turbulent and laminar) and the second operation (Tool - laminar / Target - turbulent).

For meshing, I am including all the volumes.

What would the "bit" of the fluid be?