We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Photonics › Help for qINTERCONNECT › Reply To: Help for qINTERCONNECT

November 11, 2024 at 9:42 pm
venuskd
Subscriber

Hello Devika,

 

As far as I know, we have a QINTERCONNECT license as well. However, I’m not sure what steps I should take to resolve this issue. Could you confirm if QINTERCONNECT should have an interface similar to INTERCONNECT? When I try to access QINTERCONNECT, I see the 'command prompt' window shown below:

So I am not sure, should I type anything to access this qinterconnetc interface? , and also what it should be look like? 

I am looking forward to hearing from you.

Bests,
Venus