We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Why do I need to specify target when doing MOGA optimization? › Reply To: Why do I need to specify target when doing MOGA optimization?

November 1, 2024 at 7:44 am
Erik Kostson
Ansys Employee

Hi

Say we want to minimize the mass and want it to be close to 2.5 kg, then we set Target to 2.5.

 

Hope this illustrates what it is.

 

All the best

Erik