We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Meshing Issue › Reply To: Meshing Issue

October 18, 2024 at 10:52 pm
hbwansapura
Subscriber

I tried turning off the Check Mesh Quality setting and it did not work. I am following a YouTube tutorial for creating the mesh which had no errors, so I didn’t change the settings. I am a high school student, and this is my first time using Fluent. If I were to change the settings, what would I specifically change?

Â