We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Simulation stopped to work after switching the computer › Reply To: Simulation stopped to work after switching the computer

October 16, 2024 at 4:18 pm
mohammedlaminemekhalfia
Subscriber

Thanks for the reply

despite of the wornings the model was solving correctly and the output was very compared to even the experiment.

The issue when I moved the model to the new computer it stop to solve totally, I did not change anything.

The error shown is that Internal solution magnetitude is exceeded.

Â