We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Simulation stopped to work after switching the computer › Reply To: Simulation stopped to work after switching the computer

October 16, 2024 at 3:55 pm
mohammedlaminemekhalfia
Subscriber

In the picture below the simulation run correctly those are the warnings

now the simulation does not work at all.

Yes for https://innovationspace.ansys.com/product/prevent-rigid-body-motion-in-contact/     I applied everything in it

I used the previous paramters and I even devided the time step 10 time . 

I do not have any converged step now

Â