We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Ansys Working Error › Reply To: Ansys Working Error

October 8, 2024 at 9:21 am
rani.a
Subscriber

Hi Kaushal,

Thank you for the response.
I have tried all the solutions already that was mentioned in the attached link of your response. Simplified the design and worked on it, yet receiving the same result.

Also, this is a design that has been done in Fusion and imported the step file to Ansys.

There were earlier issues with the contacts, and i have overcome them with reference to few forum solutions.

Also, I received a new error and attached below the same.