We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Ansys Working Error › Reply To: Ansys Working Error

October 8, 2024 at 8:11 am
Kaushal Vadnere
Ansys Employee

Hello,

This type of message appears when you are running the program in dynamic memory mode and the program has attempted to allocate additional memory, but it failed because it could not find a large enough contiguous block of memory to proceed.
There was a similar question on forum that has been answered previously. Please see if it helps you: Not Enough Memory Error? (ansys.com)

Let me know if this post helps you.