Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum Forums Discuss Simulation General Mechanical Stress too high in transient simulation. Reply To: Stress too high in transient simulation.

nm0770
Subscriber

@danielshaw: Thank you for your feedback. The Wöhler diagram is from the materials I actually use.

@dlooman: Even if i would place a Point Mass on the Panels?

Is it possible that this behaviour can be caused by a sensor offset. When integrating the offset the values are increasing over time?


[bingo_chatbox]