We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Workbench Mesh Offset Related Question › Reply To: Workbench Mesh Offset Related Question

August 7, 2024 at 6:34 pm
mjmiddle
Ansys Employee

When I tested this in Ansys 2024 R2, it only showed an offset with "Thick Shells amd Beams" on. What version are you using?

Your latest picture appears to show solid geometry in the geometry modeler, not the "Thick Shells amd Beams" which is only going to apply when mesh is displayed.