We’re putting the final touches on our new badges platform. Badge issuance remains temporarily paused, but all completions are being recorded and will be fulfilled once the platform is live. Thank you for your patience.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Error in cyclic symmerty simulation › Reply To: Error in cyclic symmerty simulation

July 31, 2024 at 5:49 am
Deepak
Ansys Employee

Hi,

Cyclic symmetry works by connecting the low face of one sector and the high face of other sectors as shown below,

But in your case, there might be an error in the geometry creation/preparation (can please share the top view of geometry), by observing the provided image the error might be of the case as shown below, 

Thanks,

Deepak