We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Management of Participation Factor › Reply To: Management of Participation Factor

July 18, 2024 at 4:35 pm
Ankush Choudhary
Ansys Employee

Hi,

You can use the MXPAND and MODSELOPTION commands for that. Please check out the below link on this approach.

https://innovationspace.ansys.com/courses/wp-content/uploads/sites/5/2024/01/Considering-specific-modes-in-the-Harmonic-analysis.pdf