We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum Forums Discuss Simulation Fluids Forte Sector Mesh Reply To: Forte Sector Mesh

Ren
Ansys Employee

Are you using the Automatic Mesh Generation (AMG)? If yes, you are referring to the wrong part of the manual. Please read the information further down the page.

Also, the "symmetry" boundary cannot be used for a 1/7th sector. You need to use the periodic boundary. The "symmetry" boundary is for 180-degree sector as described at the bottom of the page.

Â