We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Checkpoints › Reply To: Checkpoints

July 8, 2024 at 10:34 am
Lydia
Ansys Employee

Dear Zihan,

Ansys Mechanical has restarting capabilities. To activate those you can do under Analysis Settings 15.1.5. Restart Controls (ansys.com). 

You can check here also for more info 17.5. Using Solution Restarts (ansys.com)Â