We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Response PSD and RMS value › Reply To: Response PSD and RMS value

May 21, 2024 at 4:28 pm
deepesh.p.gurdasani
Subscriber

But just like the modes extracted should be 1.5x the last input frequency, isnt there any such rule that response RMS should be some 3x, 4x, etc. of the input RMS for the result to be correct ?