We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Transfer from Discovery to Fluent › Reply To: Transfer from Discovery to Fluent

May 7, 2024 at 7:39 pm
todd.moser
Subscriber

Well, patience isn’t one of my strengths, so maybe I just didn’t wait long enough.

I found this tutorial for meshing a mixing tank (/courses/index.php/courses/workshops/lessons/mixing-tank-2/). It was helpfull, but I haven’t found anything for the solution of the same tank. It’s a little unclear to me how to set up the fluid zone rotation, when to use mesh rotation and when mesh interfaces are needed. Any suggestions for the solution side?

I have a calculation running now and it appears to be converging but a little more training material would be helpful.