We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Fluids › Modeling Methane Explosion Ignition by Patch › Reply To: Modeling Methane Explosion Ignition by Patch

April 19, 2024 at 2:17 pm
Wu PeiNan
Subscriber

Thanks for you replied, Rob.

When I choose a semi-closed pipe to simulate a methane explosion, I always fail to ignite in this model, why is that? 

I used the simple pipe model, and I think  if that there are any requirements for the mesh?  Or which setting I ignore?

I would appreciate it.