We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › Optics › Workbench + speos 2024R1 › Reply To: Workbench + speos 2024R1

April 17, 2024 at 2:04 pm
vision
Subscriber
Yes, I noticed that optimizer is officially enabled in the new version and it runs all right.
 
We still want to use it in Workbench as well, as there are some situations where it serves as a bridge that needs to link forces, heat and optics. Looking forward to your further reply!