We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › Creating a frustum › Reply To: Creating a frustum

April 13, 2024 at 11:48 am
Aryadipta Nayak
Subscriber

And also how to add layers in acp pre setup

Hi Avnish, created the surface body in design modeller please clarify me about the rosette selection and OSS for the frustum. 

Â