Ansys Assistant will be unavailable on the Learning Forum starting January 30. An upgraded version is coming soon. We apologize for any inconvenience and appreciate your patience. Stay tuned for updates.

Ansys Learning Forum Forums Discuss Simulation Fluids Using Dense Discrete Phase Model Injection Type Reply To: Using Dense Discrete Phase Model Injection Type

Rob
Forum Moderator

 

OK, and what is the volume fraction of the solids near the inlet (hand calculation, not from the solver)? 

Basically, when a model fails the best way to troubleshoot is check the mesh and then turn everything off & then slowly turn it back on again until it breaks again. Then focus on that model/setting. 

 

[bingo_chatbox]