Hello everyone, please in AQWA is there a way to define the mooring line angle in a configuration?
I did this by using visual assumptions. But I want to believe there should be a better way as available in OrcaFlex.
You are navigating away from the AIS Discovery experience
Ansys Assistant
Welcome to Ansys Assistant!
An AI-based virtual assistant for active Ansys Academic Customers. Please login using your university issued email address.
Hey there, you are quite inquisitive! You have hit your hourly question limit. Please retry after '10' minutes. For questions, please reach out to ansyslearn@ansys.com.
RETRY