Hi Ha,
Forces can be obtained in different ways, please see the following link where this topic is discussed in more detail: https://www.dynasupport.com/howtos/general/force-analysis
In short, look for forces after you select ASCII or BINOUT as shown below with a red box:
An AI-based virtual assistant for active Ansys Academic Customers. Please login using your university issued email address.
Hey there, you are quite inquisitive! You have hit your hourly question limit. Please retry after '10' minutes. For questions, please reach out to ansyslearn@ansys.com.
RETRY
You are navigating away from the AIS Discovery experience