We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › How to change a SOLID187 into a SOLID185? › Reply To: How to change a SOLID187 into a SOLID185?

July 23, 2021 at 6:42 pm
MickMack
Subscriber

Thanks for the reply
I have added that command to all the solids within my geometry, but it still does not appear to have worked. As you can see the solver is still assigning KEYOPT2(2). 2 images shown below.

I don't see the command snippet in the solver output so i don't believe it is reading it at all. I would expect to see *****Begin Command Snippet* **** in the output file.

I'd appreciate any further suggestions on how to remedy this.

Thanks Michael