Learning Forum

[up1101164]

Hi Everyone,

i have done some calculations about the geometry of a blade for an axial blade compressor. Below, as you can see i have made an excel, with some of my calculations for each one spanwise section, by use of mealine analysis. For each one span, i have calculated the :

·         b1(leading edge angle) 

·         b2 (trailing edge angle) 

·         the camber line 

·      length of chord

On this point, i want somehow to enter them on the blade gen tool of ANSYS 2025R1, in order to create the blade by my own. 

How can i relate the parameters of my calculations with those of bladegen tool?

In addition, i would like to create a spline/curve for each spanwise section using multiple points, based on the values I already have.

Could you please explain how I can define these points and generate the spline correctly? 

 The excel file below:

 

Thank in advance for your time and assistance!