Cannot Open Files in Linux Version

- June 23, 2020 at 7:24 am
  
  Guangqi
  Subscriber
  
  The version is 19R2
- June 23, 2020 at 12:10 pm
  
  Karthik Remella
  Administrator
  
  Is this very specific to this one model or happening to every model you are attempting to open?
  
  Thanks.
  
  Karthik
- June 23, 2020 at 3:22 pm
  
  Guangqi
  Subscriber
  
  Every Model. I am new to linux Version. So is there any way that I could set the model on windows and copy some files to Linux to run it without open workbench on linux? I found the GUI on linux version is not well supported.
- June 24, 2020 at 2:26 pm
  
  Rob
  Forum Moderator
  
  Did you copy the wbpj file and folder or transfer the archive? If you did the former try the latter.
- June 24, 2020 at 4:25 pm
  
  Guangqi
  Subscriber
  
  I found when I copy the wbpj on Linux, when I click 'model', it shows the error.
  
  I create new files directly on Linux, when I click 'mesh', it shows the error. But I can open the model and run it.
  
  I will try to copy archive later.