Fluids

Fluids

Topics related to Fluent, CFX, Turbogrid and more.
  1. All Channels
  2. Fluids
  3. Problem during create

Problem during create

TAGGED: , ,

    • January 8, 2026 at 7:46 am
      damarsetyokidal
      Subscriber

      I cannot generate mesh, it always shows one or more entities failed to mesh. the geometry inside tube shaped is volume model. I'm very thankful if there's someone reply on my post

      I'm always failed to mesh on my geometry. It always tell one or more entities failed to mesh. Inside the tube shaped geometry is volume with horizontal axis wind turbine modeled. I'm very grateful if someone or anyone reply on my post

    • January 8, 2026 at 9:03 am
      Rob
      Forum Moderator

      How many volumes have you got, and do the blades have a finite thickness?

      • January 8, 2026 at 9:28 am
        damarsetyokidal
        Subscriber

        I'm not sure how to calculate the volume, also for the smallest thickness is approximately 1mm but it didn't show if there's any finite thickness because in design modeler the imported geometry is already green checked and did not show any warning or error

    • January 8, 2026 at 9:48 am
      Rob
      Forum Moderator

      That sounds like the blades are valid. Did you subtract the blades from the volume? 

Viewing 2 reply threads
  • You must be logged in to reply to this topic.
Innovation Space
Top Contributors

© 2026 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.