Learning Forum

[Md_Salem]

Hello everyone,

I am doing impact analysis for a concrete block using Explicit dynamics.

I used the default concrete Engineering data offered by Workbench, then added Polynomial EOS and J H strength. Both shear modulus and bulk modulus are frozen in the isotropic elasticity properties. After I had finished setup, I tried to run the solution, but I received an error message, "Concrete must have shear modulus defined," and it terminated.

Could you please help me figure out this problem?

[Chris Quan]

Can you make it clear about what material you have retrieved from the Explicit Material library and how did you add the Polynomial EOS and JH Strength to the material?

I tried it. I was able to see Shear Modulus defined. See pictures below.