Learning Forum

[uygar.kartal]

Hello guys,

Currently, I am running a thermal analysis in Ansys Discovery, and I want to place a sensor at the center of a sphere to view its time-dependent temperature graph. Is there a way to do that?

I would appreciate it if you could help.

[subashni.satish]

Hello,

You can create a point at the center of the Sphere and create a custom monitor at the point location.

To create the point, you can use the 3D point tool under Design Tab > Create,

Check out the below Knowledge article for tips on creating monitors.

Discovery Quick Tip- Monitors on Construction Geometry | Ansys Knowledge

[uygar.kartal]

Hello,
Thank you so much for your help that was all I need. 😀

[bradleyearnest006]

 

Your assistance was just what I needed, so thank you very much and you can try Doodle Jump. 😀