Learning Forum

[lis29]

Hi all, I'm new to Ansys Mechanical and working on a model where I'm having convergence issues. My contact tool setup result under solutions looked like this after my most recent solve (where I adjust all contacts to bonded with the intent of gradually unbonding them to find problematic contacts for convergence):

Could this indicate anything about why my model isn't converging, and in general what's the reason for it looking like this?

I appreciate any help.

[Erik Kostson]

Hi

See deformation scaling / displacement scale of results should be 1 (True Scale), and it is not that in the above image - also you are probbaly looking at an unconverged result.

All the best

Erik

[lis29]

I see, that makes sense. Thank you!