Reply To: An error occurred when the post processor attempted to load a specific result.

[azzah.balqis]

Hi everyone,

I solve my problem about the error. I see another threads about this.

This error message could be caused by various reasons. You may conduct the following checks:

1. Uncheck the box "Distributed" and set the number of cores to 1. Then click Solve. If model runs, it means that you need to install MPI tools, for example Intel MPI, before running the model with HPC ("Distributed" box checked).
2. If the WB project is stored in a network drive or a shared folder or MS One-Drive, save the project using Save As to a local drive, for example, C drive, and see if the model runs. If yes, you need to run the model in a local drive and then move the project to a safe location after the simulation has finished.
3. Check the Solver Output to see if there are any error messages about materials, contacts, boundary conditions, ..., etc. 

 

I did number 2. Hopefully this answer will help.

but it is quite weird because running model with campus computer takes more time to solve than using laptop. Although the campus computer spec is way higher than the laptop. Maybe becuase I am using Remote Desktop Protocol. If there is someone is facing same problem. Maybe you can comment in here to give me an advice. Thank you