TAGGED: -Ansys-Maxwell-electronics
-
-
November 15, 2024 at 3:39 am
-
November 19, 2024 at 7:59 amTimosAnsys Employee
Hello, this is a defect that will be fixed in 2025R1. Please consider using 2023R2 version, or simply create the Maxwell model without chaning the material in RMxprt, and afterwards change the material in Maxwell UI.
-
Viewing 1 reply thread
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- HFSS Incident Plane Wave excitement mode
- Simulation of capacitor combining eddy currents with displacement currents
- How to calculate eddy and hysteresis losses of the core?
- Ansys Maxwell 3D – eddy current
- How to determine initial position in motion setup
- dq graph non-conformity
- Simplorer+Maxwell Cosimulation results and Maxwell results mismatch
- Parametrizing coil “terminals” with coil geometry
- On-chip inductor design
- Maxwell circuit – PWM
Top Contributors
-
1406
-
599
-
591
-
555
-
366
Top Rated Tags
© 2025 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.