Learning Forum

[Energizer]

Hello everyone.

I try to simulate bullet impact on reinforcement concrete slab, but fail. Bullet just passing  through slab and left small damage. I use CONTACT_ERODING_SURFACE_TO_SURFACE between the projectile and concrete. Slab material is MAT_CSCM_CONCRETE, reinforcement MAT_PLASTIC_KINEMATIC.

Without reinforcment all good, slab desroyed under shock.

What do I wrong?

[ErKo]

Ansys employees cannot comment on this - perhaps other forum member can chime in here and advice.

Erik

[ilker.kurtoglu]

Hi,

You can reduce your timestep and reduce BSORT cycle for a better contact detection. Moreover, you can use erdoing_nodes_2_surface contact being the concrete slab as the surface and penetrator as the node set part.

If you are using SOFT=2 option, read the manual carefully for correct settings of SBOPT and DEPTH parameters.

Good luck.

İlker Kurtoğlu

[Energizer]

 

Hi,

Thank you for your advice.