Electronics

Electronics

Topics related to HFSS, Maxwell, SIwave, Icepak, Electronics Enterprise and more.
  1. All Channels
  2. Electronics
  3. OptiSLang MotorCAD single instance integration

OptiSLang MotorCAD single instance integration

TAGGED: ,

    • October 9, 2024 at 8:31 am
      nkb221
      Subscriber

      I've generated an Optislang project from the MotorCAD interface and I've run it without any parallel instances. I've found that MotorCAD has very low CPU usage a design takes roughly an hour to compute. This normally takes 10 mins max. if doing manually. Is this a known issue? Any hints on what could be going wrong?

    • October 24, 2024 at 3:22 pm
      NKC
      Forum Moderator

      Hi nkb221,
      It appears that the question you've asked is being addressed in the post below. If you have any additional questions, feel free to continue the conversation there.
      Optislang MotorCAD HPC integration

       

      Regards,

      Navya

      • October 25, 2024 at 7:59 am
        nkb221
        Subscriber

        Hi Navya, 

        That is incorrect. The issue has still not been addressed. 

Viewing 1 reply thread
  • You must be logged in to reply to this topic.
Innovation Space
Top Contributors

© 2025 Copyright ANSYS, Inc. All rights reserved.

Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.