-
-
September 19, 2024 at 11:37 pmkiran.purushothamakeshavanSubscriber
Hi,
I'm interested in looking at adhesive force an incoming particle might have on the particles which have been sticking to the wall virtually.
To show virtual sticking of the particle on a wall a force/ moment balance has been imposed where if the conditions are right the particles are trapped else it bounces off the surface.
I need to use the radii of the particle that has recently adhered to the surface with the radii of a completely new incoming particle, to calculate the force of adhesion between them.
Is there a way to save and use the radii of the particles to calculate forces between the most recent to the incoming particle that is about to hit the wall?
Thanks,
Kiran -
September 20, 2024 at 10:16 amRobForum Moderator
Not easily as an adhered particle is usually removed from the domain, and with UDMs you're recording facet data (ie mass of impact etc).Â
-
- You must be logged in to reply to this topic.
- Non-Intersected faces found for matching interface periodic-walls
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Cyclone (Stairmand) simulation using RSM
- error udf
- Diesel with Ammonia/Hydrogen blend combustion
- Fluent fails with Intel MPI protocol on 2 nodes
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Script error Code: 800a000d
- Encountering Error in Heterogeneous Surface Reaction
-
1191
-
513
-
488
-
225
-
209
© 2024 Copyright ANSYS, Inc. All rights reserved.