We have an exciting announcement about badges coming in May 2025. Until then, we will temporarily stop issuing new badges for course completions and certifications. However, all completions will be recorded and fulfilled after May 2025.

Ansys Learning Forum › Forums › Discuss Simulation › General Mechanical › No deformation, contact issue ? › Reply To: No deformation, contact issue ?

September 16, 2024 at 5:21 pm
ahasan9194
Subscriber

 

Hi Erik 

thank you for yoour reply,

i tried doing what you said but i get the same results. when i use transient structure the tube hit the die and stop but it doesnt deform. atleast it doesnt go through without deforming. 

and yes i am new to this, where do i start ? which courses ?Â