-
-
September 12, 2024 at 5:56 pmsjohnSubscriber
I would like to patch certain length of a pipe starting from the inlet. I created a region (region0) under Cell Register by specifying the coordinates (min & max) but it didn't select the inlet face (seen in blue in the attached figure). I created another region (region1) containing the inlet face but under Patch, it wouldn't allow me to patch both regions.
-
September 12, 2024 at 5:57 pm
-
September 17, 2024 at 12:40 pmRobForum Moderator
What do you see if you plot the volume fraction down the z-centre plane?
-
September 17, 2024 at 7:50 pm
-
September 18, 2024 at 4:34 pmRobForum Moderator
That's fine. You may find the inlet gives an odd result depending on what's entering the domain and whether it's done an iteration.
-
Viewing 4 reply threads
- You must be logged in to reply to this topic.
Ansys Innovation Space
Trending discussions
- Non-Intersected faces found for matching interface periodic-walls
- Script error Code: 800a000d
- Unburnt Hydrocarbons contour in ANSYS FORTE for sector mesh
- Help: About the expression of turbulent viscosity in Realizable k-e model
- Fluent fails with Intel MPI protocol on 2 nodes
- Cyclone (Stairmand) simulation using RSM
- error udf
- Diesel with Ammonia/Hydrogen blend combustion
- Mass Conservation Issue in Methane Pyrolysis Shock Tube Simulation
- Script Error
Top Contributors
-
1281
-
543
-
524
-
481
-
231
Top Rated Tags
© 2024 Copyright ANSYS, Inc. All rights reserved.
Ansys does not support the usage of unauthorized Ansys software. Please visit www.ansys.com to obtain an official distribution.