Learning Forum

[rx20729]

Hi,

I am trying to run some stability analysis within Ansys Hydrodynamic Response on a vessel that I have modelled. However, I am running into the following error:

The model is made up of three interacting structures and I am also using some non-linear catenary mooring lines that are connected between connection points on the structures and fixed points on the seabed. The error does not occur when I run stability analysis on the main vessel, however, when I add the other two structures and the mooring lines to the model, I receive this error message and also the whole structure moves significantly.

Any ideas as to what could be causing this error message will be greatly appreciated.

Thank you.

 

[Shuangxing Du]

You could set Maximum Error in Equilibrium to be Manual Definition, and adjust the Maximum Positional Error

[rx20729]

Hi,

Thank you for your reply.

I have tried this and I am still getting the error.

I have also manually defined the movement limitations per iteration and the error is still occuring.

[Shuangxing Du]

Can you please show your model?