Learning Forum

[chatte29]

Hi, 

All I am simulating is a simple bus bar carrying some high frequency sinusoid current and I want to study the field around it. Thats it. So I have a parametric setup to vary the current angle theta. Now I run the solution setup, then the parametric setup. Plot the B field. Then from the left side, find the Field overlays, go to B field, then right click and hit animate and nothing happens. It just shows me one frame, that is the starting theta angle. 
Any ideas? 

[Navya Chode]

 

Hi Prateekee Chatterjee,

Did you set up the save fields during the Analysis setup?

Regards,

Navya

 

 

 

 

[chatte29]

I was working in the magnetostatic solution. Are you saying that having a transient solution setup is more suited to this?

Even so, I have previously used magnetostatic to animate fields, B field by having a parametric setup to vary theta. 

[Navya Chode]

 

Magnetostatic simulation is enough for your requirements.
Is the create animation setup window pop up when you right-click on the plot and select animate?
On this window select the appropriate parametric variable.

 

[Yusuf Tarık AKYÜZ]

Hi friends. I also have some problem. I am working on Maxwell DC Conduction and Electrostatics. When i want to make an animation in DC, I cant see any swept variable. How can i add swept variable?