Axial ducts in RMxprt

- March 13, 2024 at 9:05 am
  
  Vidyabharati Ippili
  Subscriber
  
  Is it possible to model axial ducts in RMxprt? I could see that whatever ducts we are entering in RMxprt for Induction motor are radial ducts. Any suggestions regarding this?
- March 24, 2024 at 5:33 pm
  
  GLUO
  Ansys Employee
  
  Hi,
  If you are talking about the duct at the same direction of shaft, then it is in the rotor vent settings.
  GL
- March 26, 2024 at 6:38 am
  
  Vidyabharati Ippili
  Subscriber
  
  Hello GLUO,
  I am referring about the stator ducts along the direction of the shaft.
  Regards,
  Vidya
- March 26, 2024 at 5:11 pm
  
  GLUO
  Ansys Employee
  
  The Generic Rotating Machine Induction machine template has axial duct in the stator vent definition.
  GL