Required torque too large MotorCAD-ModelLab-OperatingPoint

- March 7, 2024 at 12:22 pm
  
  Francisco Ibáñez López
  Subscriber
  
  Hello, I built a 6 phases induction motor in MotorCAD, but when I try to calculate a operating point in the ModelLab I have a problem with the torque. For example, with 30Nm, I obtain that required torque is too large, and MotorCad makes the calculations with 0Nm. I dont know what could be the problem, thank you.
- March 13, 2024 at 4:08 pm
  
  MirandaH
  Ansys Employee
  
  Hi, please submit a service request with your model attached, Ansys support engineers will assit.