HFSS intersect error

- February 6, 2024 at 3:53 pm
  
  Buddhika Kumara
  Subscriber
  
  Hell guys,
  I'm a bigginer to HFSS 3D softwear. So i'm trying to simulate a Resonator model and Im getting the intersect error betweeen the input strip line (copper) and the resonator ( alumino silica). I'm using Rogers duroid 5870 as the emounting board and Ceramic resonator on top of the input strip line and out put is a copper wire. Could you please help me to fix this error
- February 7, 2024 at 1:09 pm
  
  Mrinmoy Bharadwaj
  Ansys Employee
  
  Go to HFSS>Design Settings>Set Material Override and turn ON the "Enable Material Override" as shown below:
  - February 7, 2024 at 4:29 pm
    
    Buddhika Kumara
    Subscriber
    
    it worked thank you very much.