3-D Assembly component distorted while performing Ansys Simulation

- October 15, 2023 at 6:24 am
  
  p23me001
  Subscriber
  
  Hello everyone, I am facing issues related to component distortion from the cross flow hydroturbine assembly while running the simulation in the solution part of the Ansys Fluent. I have eliminated the issues related with meshing by keeping orthogonal quality nearly around 0.15 (by modifying parts of the geometry), but still I am facing such type of component distortion attached herewith and also a "floating point exception" error is indicated in the solution while trying to run the simulation. I would be grateful if anyone could solve this problem.
  
  Thanks & Regards,
  Jyotipriyam Baruah
- October 19, 2023 at 11:07 am
  
  Prashanth
  Ansys Employee
  
  Hello, can you please clarify what you mean by component distortion? If you are using sliding mesh, preview the mesh motion to disregard any issues on that side.