-
-
September 22, 2023 at 9:50 am
xinglong.wu
SubscriberDear ANSYS experts,
Several months ago I posted a question/potential issue in the forum (see the link below) and then I provided detailed information as required.
/forum/forums/topic/dipole-simulation-with-hfss/
However, several months passed and up to now I haven't received any further replies.
If it is possible, can you provide us further suggestions? I would be also available to share the project if you provide a space to upload it.
Many thanks.
Best regards,
Xinglong
Â
-
September 27, 2023 at 3:19 pm
Praneeth
Ansys EmployeeHi Xinglong,
Thank you for reaching out to the Ansys learning forum and sending a reminder for not getting back to the reply in time.
Please note that a reply is provided to the mentioned post. Kindly use the same post for further replies.Â
I am closing this post to avoid replies.
Best regards,
Praneeth.
-
- The topic ‘Reminder: dipole simulation issue with hfss’ is closed to new replies.
- Y wiring method and the start and end points of winding.
- Lumped Port Deembed
- Optimizing Via Impedance in Ansys HFSS 3D Layout Using Geometric Parameter Sweep
- Hfss 3D pcb via capped and filled with epoxy
- AEDT Natural Convection with default correlation is failing solver initializatio
- HFSS libnvidia-ml.so too old or could not be found – Warning in slurm job output
- Three-Phase Voltage Imbalances in dual stator electric generator
- STL Import Errors in HFSS After Cleaning in SpaceClaim
- Calc Error in Field Calculator after PyAEDT Analyze
- import file autocad 3d
-
3882
-
1414
-
1241
-
1118
-
1015
© 2025 Copyright ANSYS, Inc. All rights reserved.